Master Flash® design meets all roofing needs. Sleeve flexibility accommodates vibration and pipe movement caused by expansion contraction. The soft aluminum base easily conforms to most metal roof profiles.
Made or EPDM, these flashings are compounded specifically for maximum resistance to weathering due to ozone and ultraviolet light.
The base is designed to form a seal on most panel configurations and roof pitches regardless of pipe location.
Fast, one piece construction allows for easy on-site installation usually 5 minutes.
Easy to see pipe diameters make for painless on-site installation.
• Accommodates:
ONE 0” - 1-15/16” (0 - 49mm) pipe
TWO 3/8” (9.6mm) pipe / cable
TWO 3/4” (20mm) pipe / cable
* Master Flash; the only CSA Approved EPDM rubber flashing.
Density:
Elongation:
Compression set:
Water absorption:
(Does not absorb water)
2 pcf - no shrinkage
120% (% to break)
28% (% original thickness)
0.04 - lb/sq ft
Tensile strength:
Tear resistance:
Shore hardness (A):
Working temperature:
43 psi
11 - lbs/in2
7
-70°F to +175°F